|
 |
/
Biosecurity /
Liquids /
BioKleen |
|
|
 |
 |
|
 |
|
Good Management,
Biosecurity and Vaccination are the key parameters for sound
performance of a flock. Keeping a disease out of the flock is
always better than to manage a disease outbreak, which is never
completely possible and at the same time leads to huge
irreparable losses. The primary focus of the farmer is always on
more production with expectation for more….more…and more.
In this situation, the bird invariably is under stress which
makes it easily susceptible to contract and spread diseases,
especially the viral diseases, which are the most rampant with
severe losses. The only possible method that can be adopted is
to provide an environment, free of microbial contamination thus
avoiding diseases in the herd. The major routes of contracting
disease are through feed, water, air and contact, which if could
be checked can prevent dreadful diseases and thus maintain a
healthy herd.
Aldehydes – Glutaraldehyde and Formaldehyde have a wide
range of antimicrobial activity against bacteria, their spores,
both enveloped and non-enveloped viruses, fungi and protozoa.
Quaternary ammonium compound – Benzalkonium chloride is
least toxic, less corrosive and known for their excellent
surfactant activity which makes them bactericidal, virucidal
(enveloped viruses) and fungicidal in a formulation. Aldehydes
and Quaternary ammonium compounds together make an excellent
synergistic disinfectant that checks all possible pathogenic
microbes affecting bird’s health.
Keeping this synergy in view, an excellent formulation
“BioKleen” has been evolved which is a potent blend of
benzalkonium chloride and aldehydes, featuring an excellent
broad spectrum disinfectant property with its proven
effectiveness against bacteria, their spores, virus, fungi and
protozoa, thereby defending poultry health.
Formulation
Benzalkonium Chloride, Glutaraldehyde, Formaldehyde
Mode of
action
The unique formula of BioKleen permeates and alters the
structure of the cell membrane, allowing itself to “drive
inside” the cell to destroy the microorganism. The high cationic
surfactant activity of Benzalkonium chloride (lipophilic)
damages the cell membrane of the micro organism and alters the
membrane permeability leading to leakage of the vital cellular
components. Following disruption of cell membrane, formaldehyde
and glutaraldehyde (which are hydrophilic) gain entry into the
cell and causes irreversible destruction of cytoplasmic
organelles and finally kills the cell.
Special
Features
Can
be used at low concentrations
Absence
of development of resistance by microbes
Non
toxic to animals at user dilutions. It can be sprayed in the
air, on walls and floors in the presence of poultry
Non-corrosive,
non-staining, odorless at user dilutions and easily miscible
with water
Effective
in the presence of organic matter
Temperature
resistant
Possesses
residual activity
Cost
effective
Spectrum
of activity
Wide antimicrobial spectrum - effective against major bacteria,
their spores, virus, fungi and protozoa affecting bird’s health.
Directions
for Use
Empty sheds: Remove all fixtures from the shed. Scrub
walls, floor and roof. Dilute 40 ml of BioKleen per liter of
water. Spray roof, then walls and finally floor. Allow shed to
dry.
Sheds with poultry: 4 ml per liter of water. Spray in air
towards ceiling once or twice a week.
Metal equipment: 10 ml per liter of water. Soak the
instruments for 30 minutes and then rinse.
Plastic equipment: 20 ml per liter of water. Soak the
equipment for 2 hours.
Feed rooms, stores: 20 ml per liter of water. Apply as a
spray to check aerial contamination.
Foot baths: 10 ml per liter of water that checks possible
contaminations by staff, visitors and vehicles.
Presentation:
500 ml, 1.0 liter and 5.0 liters
Caution:
Avoid
contamination of feed or water.
Do
not house poultry or other equipment until the treatment has
been set, absorbed or dried.
While
spraying in presence of birds do not spray directly on to the
birds.
Do
not contaminate feed or water. Keep away from children. |
|
|
|
|
|
 |
Biosecurity
Formulations - Liquids |
 |
|
|
|
|
|